Thanks Zax. I will try this and report.
Regards
X
Xan V.
@Xan V.
0
Reputation
3
Posts
27
Profile views
0
Followers
0
Following
Posts made by Xan V.
-
RE: draw module not raising
I've tested both modes, laser and servo mode in EleksCam, with the same negative result. Is that the way to configure the firmware?
-
draw module not raising
Hi,
I've bought an EleksLaser and it works perfectly. Now I'm trying it with the draw module without success. I have EleksMaker Mana SE v 3.2 and I am using EleksCam to control it. So when I turn on the software, this module doesn't raise. I switched between laser and servo socket and no results neither. Am I doing anything wrong? which settings must be applied for this task?
Tnx in advance.