I move the PCB whit the mising led to the last number and it work even the number 9 but whit one led ofcurse I'm happy but if you can tell me where orther one PCB whit LEDs to replace and have my number 9 full power.

Thanks super cloke I love it

Update: Looking into this further, the connector shown on the left has a pitch (spacing between the four wires) of 1.25 mm however the printed circuit board requires a pitch of 1.0 mm. So it's impossible to connect the wire to the board using the parts as given.

It's strange wiring that doesn't fit would come with the kit!

Please help! I'm ok to buy a wire one the open market but I'm having some difficulties finding one that would fit propely.

You have probably assembled it backwards try plugging the wires for the led from the mainboard into the otherside of the chain of leds

@AdHocGrip

I too have had this problem since almost day-1. It was reported here by me as well as others. eleksmaker faffed around with little response but finally John said in an email:

"This version is really too old, do you mind to buy a new one, but it's kit need to assembly by yourself, I can offer price $99 with shipping cost."

In other words, buy a new one to replace the one that never worked!

Don't hold your breath on this one ...... I've written it off.

@abdulaziz This post has nothing to do with the EleksTube.

Please use the other topic you made: https://forum.eleksmaker.com/topic/3149/add-spindle

@Filfaere Is it the standard CH340 driver? If so, yes this is compatible with Windows 10. You can download from the manufacturers website http://www.wch.cn/downloads/CH341SER_EXE.html

Surely someone knows what's going on can somebody take a look at the source code and see what's wrong.

@mlquillin You need to wire it starting form the opposite side that you are doing now (below wiring)

@Maheshps 10W diode laser: https://endurancelasers.com/diode-lasers/10w-endurance-laser/

If you are looking at a cheap Chinese 10W diode laser then at best it's a 6W diode being over driven and will not last long.

You can use your existing board, only connect the TTL signal and ground (S and - pins on the Mana board) and power the laser driver directly.

OK no worries I got it backwards now its working fine.

Hello,

Check this topic.
https://forum.eleksmaker.com/topic/2739/elekstube-is-a-production-fail

@Zax said in How to order new updated pcb:

@dnaman Have you opened it, surely you would know if it's what you need?

One is a bunch of electronics.

The other is a bunch of ..... electronics.

I realise you're smarter than the rest of us Zax - no need to flaunt it.

@Kieran thx for understood