dunno but you can just change your regional settings in windows to America which is all the fix does.

@Ashan said in EleksCAM丨V3.1.0 Release 4.16.2017丨Full AutoMatic Engraving SoftWare:

@Anatoly Dear Anatoly,

This simple configurations i know, problem is not the port. ill notice problem is my mana ardiono board.
did know how to Full reset firmware ? i think it might be recovered, i don't know what is actually happened. when i power On lacer it always ON note moving X,Y,Z moters. please help me..

Thanks
AG

RST ROM is how to firmware reset.

You not select PORT as I show in picture. When you not select PORT and give power to laser board laser go full power.

Problem is you not select port to connect laser to computer.

Try swapping the driver between X/Y and see if the problem follows, then you know for sure the driver is bad. They are very cheap to replace or you can try to get replacement Mana SE board from the seller.

When I try to run EleksRom I get "eleksrom.exe is not a valid Win32 application". Any ideas?