Problems
-
hi, me built machine within 4 hours. And after that all the problems began
1 problem. elekscam would not even open after download (win10)
2 problem. i download lasergrbl but only one axes moved not both which result in just a burn mark
3 problem. i download d2laser and when i tride to run firmware i would get an upload error
i will send it back to gearbest if nothing is compatible thx.
-
I already posted on your other thread but since you posted in T2Laser section I will respond here as well.
Please post a picture of your control board. T2Laser is compatible with any Grbl based system, what happens when you select the correct COM port and baud rate and connect? Do you get the connect string?
-
Hi.. hv u installed VC and .net 4 from elekscam download page.. those are required to connect ur machine..
-
@vivek.khanna yes i install vc and .net already on computer
-
What is your machine make and model?
-
@vivek.khanna it is a eleksmaker a3 pro laser engraver 2500mw
-
I think then there is probably some issue with your operating system. all these software works fine with eleksmaker and windows 10.
