6A Power Supply
-
I am upgrading the existing adapter with a 12v 6A supply adapter because I think when the engraver motors moves, 2.5A is not enough power to control everything as I have observed my laser power RPM drops while arms moves in Eleksdraw (with 2500mw TTL laser).
Anything that should be kept in mind, Is it recommended/Not recommended, suggestions?
-
@vivek.khanna No, it's just a 12VDC supply. 3A should be sufficient for a 2.5W laser and motors, but you can't go wrong with a 6A!
-
so 6A will do the job right
, may be if I upgrade the laser, it will help more. that time. There will be no harm connecting to the board>??
-
@vivek.khanna No, the power (actually the current) will only be what is needed.