Higher Power Laser for A3
-
I have just purchased the 1600MW to replace the 500MW laser module on the A3, but it has arrived with new small power insert for the EleksMana SE, is their a requirement to fit the new part?
Any advice would be welcome, as i have not fitted the new module yet.
-
I'm not sure what you are asking, or what the "small power insert" is, perhaps you can clarify the question.
-
@Zax It is a small circuit board that accepts the male input from the power source.
There is a three pin connector on one end and the female power input on the other end with the off/on button . Just wondering if there is a need for it?
Thanks for reply
-
@albert It's a board to check the laser, no you don't need it.
-
Thanks