Stepper motors not moving
-
i have a red light on under the green light not sure if this is causing the problem. its hard to see as the green light comes through stronger
-
I don't think that is a problem. Mine is an older version but it only has red lights on it. So on mine red means good. On those three red boards there are Philips screwdriver heads. Those are what you move to adjust stepper driver voltage. What software are you using? Elekscam?
-
ive tried with elekscam. universal G code sender and the benbox software all seem to be running just not motors
-
If it were me I'd pull out my multi meter and see if when you send a command to move the steppers you get any juice coming out of the stepper drivers. If not it could be a software issue. If so it may be that they are not supplying enough voltage and need to be set. It's unlikely to be a dead board. Unless you see a break or something. This is a very simple machine. Usually settings or firmware are the problem. I'd stay away from benbox it's not setup for Mana boards.
-
Sounds like a dead power supply to me, have you checked that?
-
no ive not checked the power supply will look into that tomorrow i know someone who has the equipment to check the motors
-
Now that zax says that, that sounds like a very likely problem. I've heard of several bad power supplies and it would match your symptoms.
-
@11robert11 said in Stepper motors not moving:
ive tried with elekscam. universal G code sender and the benbox software all seem to be running just not motors
Hi,
When You push down the power button , is that blue LED light on?
-
@EleksMaker-Z no i have no blue LED light
-
so that your mana power is broken.... you can try discharge welding of
this cap and try again
if that didnt works , you can post your falid here:
http://forum.eleksmaker.com/category/25/eleksmaker-official-after-sale-service-areaand then use our serial number contact your saler
-
Hello
I had the same problem the X engine was not workingBy turning the potentiometer of X it has started
But the laser no longer worksBefore it moved on Y, X not working
Now neither X nor Y
-
@11robert11 Hello
I had the same problem the X engine was not workingBy turning the potentiometer of X it has started
But the laser no longer worksBefore it moved on Y, X not working
Now neither X nor Y
-
it was the power pack sent with the CNC router that dont work. i took it to someone who had a power pack pluged it in a blue light came on. ive just had to spend £15 on a new power supply its moving all the motors now but z axis motor is grinding and not moving freely ive adjusted the back but still not working im sure its a fault caused by all the tinkering to get the motors to run at last
-
i have problems whit the x stepper it goes 1 direction no matter if i left or right button use on benbox
-
@Bertus-Martena well first off delete benbox. second download elekscam or t2. Follow the instructions to switch from benbox to elekscam here. Install the new firmware and report back how your machine is reacting.
-
@nottingham82 i have done that yet it works fine accept the x carrier
i belive the board is on x terminal dead but is it my be possible to change z terminal to x terminal end z terminal to the dead end i dont need z mybe some body can help me whit this if i set the x stepper on y terminal it works fine bold sides the Original x terminal cant take it any from me
-
This post is deleted!
-
@mrmister well he can't change the assignment he can certainly swap the driver to see if the driver is bad.
-
Just pull the red stepper driver from the board with it completely powered off and disconnected from the steppers and swap it with the z axis.
-
This post is deleted!