First “big” engravings
-
Hi folks,
Just wanted to show you my first “big”engravings.
I used T2 laser for all of them.
IKEA ‘Aptilig’ chopping Board (24 x15 cm)
Feed rate: 1500
Power: 200IKEA Cork
Feed rate: 3500
Power: 180If you have any suggestion to do better engravings please tell me!!!
Hope you like them!
-
@alvar0.ga Fantastic work. I am curious on the cork as my results always smeared due to the ash and I don't like to seal it because then the cork won't absorb moisture - did you find this to be a problem?
-
@Zax said in First “big” engravings:
@alvar0.ga Fantastic work. I am curious on the cork as my results always smeared due to the ash and I don't like to seal it because then the cork won't absorb moisture - did you find this to be a problem?
Hi Zax,
Thanks for your comment. I am happy you liked it, furthermore comming from the T2 developer😊.
To my surprise it didn’t smear too much. Of course if you rub it gently with the finger you get some dirty in it, but not a lot.
I thought this was not going to work, as my grandpa used to paint fake moustaches on us with burned bottle corks when we were children 😅.
I am happy with the results though.
-
Here you can see another example I made in cork.
Feed rate: 3500
Power: 180
Res: 0.2The task for tomorrow is to install the pulldown resistor for the laser and the limit switches!!
-
@alvar0.ga That's awesome, I will try your settings next time
-
Very good work indeed. I like those.
Don W