main motors doesn't move
i assembled the eleksdraw after loosing the steel bar.
i installed the program.
followed the instructions.
i launched a standard drawing.
the motor that lift the pen works correctly.
the 2 motors that control x and y axis doesn't.
i don't know what to do.
to much tension on the belt? i don't think so...
@Ranger_Trivette Are you sure you've got 12V power to the board? No power = No motors! Servo is 5V from USB so that will still work as would the Nano microcontroller.
i can move the motor. manually, using the 4 arrow commands.
i can also control the "laser on/off" to lift the pen.
but if i try to draw a standard drawings, like "standard doraimon", the main motors doesn't move.
the pen goes up and down in the same position.
@Ranger_Trivette Sounds like a software issue, is this using EleksCAM?
i don't remeber which software i am using.
DownLoad EleksCAM v3.1
DownLoad NET Framework 4.0
DownLoad VC windows 32bits
DownLoad VC windows 64bits
which software should i use?
i can uninstall and install the right one
@Ranger_Trivette I can only speak of my software, T2Laser. It will work with your machine, the trial is free to use so you can evaluate performance and test your machine.
i'll try it immediately. thanks