Old vs. new control board and z-probe
-
My EleksMill came with the v2.1 controller board with the yellow connectors.
The "PR" pins worked fine for using the Z-probe with autolevel.
But then the board died.
I bought a new board.
They sent me a v5.2 board.
It has the 14 pin black connector.
Has anyone figured out if any of those pins are the same as the "PR" pins on the older board?!
This is the picture that shows the pins -
https://img.staticbg.com/images/oaupload/banggood/images/AC/06/8160bf53-7aca-4e88-b101-60eaff3c83d0.jpgDoes anyone know what the A0,A1,A2,A3,A5,D9,D10,D11,D12,RX,TX pins are for?
Thanks!
-
@kevinvw2000 A5 is the standard probe pin for Grbl.
-
@Zax Thanks for the info. Do you know if I go A5 to Ground?
-
@kevinvw2000 Yes. That's how the probe function works, it is normally open until the probe makes contact.
-
@Zax Thank, I will try and out and let you know if I get it working.