scan mode in eleksmaker fail



  • So far the finest detail i got with the laser was with the scan setting in the eleksmaker a3 pro software. But after running the t2laser software from an other laptop it does not work anymore. The laser start to move but does not burn. Is there a similar mode in the t2laser program? Or how can i remove the firmware so the eleksmaker software will work again? The programs are on two different laptops


  • Developer of T2Laser Software

    @woppie09 I'm not sure I understand your problem or question. You are using T2Laser with my Grbl 1.1e DEFAULT firmware? It should work correctly with the EleksMaker laser, you can adjust the resolution (quality) to get the finest detail.


Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.