Can i use my laser with your software?
-
I have just bought one of these https://www.banggood.com/5065cm-Engraving-Area-3000MW-Laser-Engraving-Machine-DIY-Kit-Desktop-Laser-Cutting-p-1268114.html?rmmds=myorder&cur_warehouse=CN is it possible to use your software with it or should i switch out the control board for an eleksmaker one? And if so should i get the board that does all 3 axis in case i want to do rotary in the future?
-
@Bartash Yes, T2Laser will work with that machine. The 2-axis controller can be used with rotary mode in T2Laser, you swap either X or Y for the rotary so no need for a 3-axis board.