Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Cant gey T2 laser to work

M

mrmister Active Member
last edited by

This post is deleted!
Reply Quote 0
Replies: 0
M

mrmister Active Member
last edited by

This post is deleted!
Reply Quote 0
Replies: 0
Zax Developer of T2Laser Software
last edited by

You may not have had the correct COM port selected, or if you haven't already installed the drivers perhaps that the problem. You can click "Install CH340 Driver" in the Help menu to load drivers, and then make sure you have the laser COM selected and click "Upload Firmware".
Reply Quote 0
Replies: 0

3
Posts

2711
Views

Log in to reply

1 / 1