Servo Issue
-
Hi, I tried to cut some vinyl with the eleksdraw pen module.
I uploaded the eleksmana firmware and at the beggining when i moved an axis it moved diagonaly but i reset gbrl parameters and it's ok.
I then adjusted the laser power so the vinyl cutter doesn't hit the servo. i put it in 32. BUT when i try to cut it goes all the way down.
-
-
I think i see what's happening. I corrected the laser power to 32 but at the beggining of the code it is still 50. How can i change this?
-
@kdaffy The manual laser power setting has no effect on G-code, you need to change the laser max on the design screen and regenerate the G-code.
-
Thanks that was the solution. The pattent is good for cutting vinyl but the servo isn't so accurate. So it would be better a z axis. Eventhough I'm happy with the result.
-
@kdaffy I had good success with the servo but use a weight to apply the force and just let the servo lift as needed, the problem was the supplied servo is poor quality but a good metal gear hobby servo fixed that.