Servo Issue



  • Hi, I tried to cut some vinyl with the eleksdraw pen module.
    0_1576172860377_IMG_20191212_194121.jpg
    0_1576172835870_IMG_20191212_194110.jpg
    I uploaded the eleksmana firmware and at the beggining when i moved an axis it moved diagonaly but i reset gbrl parameters and it's ok.
    I then adjusted the laser power so the vinyl cutter doesn't hit the servo. i put it in 32. BUT when i try to cut it goes all the way down.



  • 0_1576173436320_Annotation 2019-12-12 195639.jpg



  • I think i see what's happening. I corrected the laser power to 32 but at the beggining of the code it is still 50. How can i change this?


  • Developer of T2Laser Software

    @kdaffy The manual laser power setting has no effect on G-code, you need to change the laser max on the design screen and regenerate the G-code.



  • Thanks that was the solution. The pattent is good for cutting vinyl but the servo isn't so accurate. So it would be better a z axis. Eventhough I'm happy with the result.


  • Developer of T2Laser Software

    @kdaffy I had good success with the servo but use a weight to apply the force and just let the servo lift as needed, the problem was the supplied servo is poor quality but a good metal gear hobby servo fixed that.


Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.