Rotary
-
Hello, We have just bought the EleksMaker Rotate Engraving Module to etch tumblers. I would like to use the T2Laser program. I have set the diameter in MM like I have read to do but it is etching designs with a slant like they are italicized. Any ideas?
-
@Begley Can you post a picture? It sounds like a mechanical issue of some kind but without seeing the result it's difficult to say.
-
yes, what would you like a picture of?
-
@Begley I just need to see the image and result, so I can understand how it's distorted.
-
This post is deleted!
-
-
@Begley You must be losing steps on each scan, possibly the feed rate is higher than it can achieve?
-
I had same problem. Enable rotate and make sure you calibrate. Also tumbler has to be straight.
-
@ELMOSLASER If it were stretched I would agree but this appears slanted so unless it's slipping or losing steps I can't see how that's possible.