Eleksdraw is not drawing after restart



  • I am using EleksCAM v3.1. need to do varies step to get the Eleksdraw working like driver install, ROM reset, and changing the ROM with EleksROM V3.8.

    and it took almost 1 hr to make it working. any possible solution.
    Not working means:-
    it shows the preview, pen up and down will work. when i start draw it goes to correct possition and start draw but it wont move. it draw with up and down the pen in the same position


  • Developer of T2Laser Software

    @Binoj-PJ You only need to setup the machine (device driver) and firmware (configure for EleksDraw) once, in future it should just work. If not, that's a software bug in Elekscam.


Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.