electrical connections



  • does anyone happen to know what type of pin connectors the eleksmaker uses I'm looking to extend my machine and need to redo the wiring


  • Developer of T2Laser Software

    @sock The connectors on the controller board are JST XH 2.5 mm 4 pin and the motor end is JST XH 2.0mm 6 pin. You can buy a set of 4 in either 1m or 2m length for ~$4 so unless you have the connectors it's better to buy them assembled.


Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.