Making the server pen work



  • Have just bought the Eleks Draw. How on earth do you get the pen to work. The server for the pen does not move. Any advice much appreciated


  • Developer of T2Laser Software

    @spareroom You need to configure the firmware for EleksDraw which is CoreXY and Servo mode and set the max value to 55 or less (in T2Laser this is a single click in the menu), if you didn't do these before connecting the servo it is probably damaged (cheap plastic gears get shredded almost immediately as it will over travel).

    0_1610131105213_t2laser_eleks_menu.jpg


Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.