EleksDraw Pro assembling issue

[Alexis_Mac_Coy]

Hi there!

I'm facing an issue to set up the belt on my EleksDraw Pro.
I don't know how to fix it as the piece doesn't look like the one in assembly instructions.
Here is a picture of my problem:

Any comment will be more than appreciated!

Thanks a lot!

[MuuSer]

@Alexis_Mac_Coy
Read this: http://forum.eleksmaker.com/topic/256/how-do-i-fix-the-drive-belt or http://forum.eleksmaker.com/topic/220/draw-pro-assembly-instructions-terrible

[pledgy]

@Alexis_Mac_Coy You need to feed the belt back through round the screws and clamp the belt on itself with cable ties. Having said that you should have a different end piece in your kit that uses the silver clamp to hold the belts.

[Alexis_Mac_Coy]

@pledgy : Thanks for your answer. However, I'm not sure to have another end piece to use with the silver clamp! Which one are you referring?

[Alexis_Mac_Coy]

@MuuSer : Thanks. I will have look to these threads.

[Alexis_Mac_Coy]

So the proper piece is this one!

Seems to be unfinished!

[MuuSer]

@Alexis_Mac_Coy

Seems to be unfinished!

Just peel the paper out and it's finished

[Zax]

@MuuSer