Eleksmill Spindle wont turn on



  • Hi there. I have a problem with the spindle. It simply wont turn on in Elekscam or Grblcontrol. It was working perfectly fine with a few projects completed. The laser module was used and when the spindle was plugged back in this is the problem that was experienced. I think it might be a firmware issue?


  • Developer of T2Laser Software

    @DDUJ It could be a firmware issue but more likely the MOSFET has failed, you would require a volt meter to check the controller outputs. If the D11 output on the Nano is working and the MOSFET is not switching then you need to replace the MOSFET or get a new controller.


Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.