Eleksdraw servo resolution
I have the normal (non pro) Eleksdraw.
The pen up/ down resolution is very low. Can this be improved so I have finer control of the up / down position?
Sending S GCode commands there are only 5 steps between S35 (my chosen up position), and 53 (down). These are S53, S48, S43, S38, S35
The reason I want this control is to be able to bring the pen down gently and avoid smashing the nip into the paper.
@mrboni Something is wrong, pen down should be around S60 and pen up at S0. You should have at least 12 steps using +/-5 values. Pen down (force) is gravity and up is lifted by the servo.