Eleksdraw servo resolution



  • I have the normal (non pro) Eleksdraw.

    The pen up/ down resolution is very low. Can this be improved so I have finer control of the up / down position?

    Sending S GCode commands there are only 5 steps between S35 (my chosen up position), and 53 (down). These are S53, S48, S43, S38, S35

    The reason I want this control is to be able to bring the pen down gently and avoid smashing the nip into the paper.


  • Developer of T2Laser Software

    @mrboni Something is wrong, pen down should be around S60 and pen up at S0. You should have at least 12 steps using +/-5 values. Pen down (force) is gravity and up is lifted by the servo.


Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.