Cutting boards
-
here is a commissioned cutting board I did near chrismas time. This was the biggest I could do without a machine move on my little A5. I masking taped it and used 750mm/min. This was done with an eleksmaker A5 with an L7 board and a 2500mw laser and T2 software.
-
That looks really nice, excellent work.
-
Nice!!!
-
Very Nice!
-
I think this is a really nice piece ,how does the masking tape help
-
This post is deleted!
-
yes so without tape you could not get the wheel tread. The smoke all around it would stain it and cause it get washed out. Tape gives good contrast and protects the woods finish around the engraving. If you plan to paint it also acts as a prefab mask.