EleksDraw Software/Cabling help, Please
-
I have the EleksDraw and loaded the EleksMaker software. One of the stepper motors is attached to X, One attached to Y1 and the servo (to the Servo pin port). I can load up the EleksMaker software and the X/Y grid works fine but the pen servo makes a loud jittering sound almost like it is trying to make micro adjustments or something.
I tried turning the connector around but then it does not work at all.
Help
-
Hello @fkersh
Try http://forum.eleksmaker.com/topic/11/eleksrom-v3-6-丨-full-automactic-upgrade-and-set-param-software-download-instruction/8
Probably you must reflash your Mana board. It helped me with EleksEGG as suggested @EleksMaker-Z on http://forum.eleksmaker.com/topic/67/problem-with-servo/10.
-
Thank you for the quick response and I did load that software/Firmware into the system but the issue now is how to control the Drawing instrument (servo) to engage or disengage? I see all of the controls for the x/y and that works great it is just the servo that is not engaging.
-
@fkersh
Laser ON/OFF button moves pen servo. Perhaps you must adjust default laser power for that. I adjusted it so that it is almost in left side. Just a left border is seen. And Default Weak Laser is in maximum left or zero.
In EleksEGG with laser off, pen is down and with laser on, pen is up.
-
Found that the pen servo fried (not sure why) but a quick trip to the RC Hobby store and now I am back in operation. Thanks for all the help.
Now just trying to find out how to use the software
I just want to sign my name with it but it either fills in the letters when I just want it to make one stroke just like in the demo.
-
@fkersh
For demo like experience use http://forum.eleksmaker.com/category/16/g-code-tool丨inkscape and make G-code. After that you can send it to your EleksDRAW with EleksCAM.
Only with EleksCAM you can't now achieve what you want...