EleksMaker Brand New Draw Module
-
Now , EleksMaker Official Store start offering Draw Module modules , which can turn your EleksLaser machine into draw machine , and only sell for 9.9$
Click Here To Buy Now
-
NICE!
-
i'll wait a bit as comined with postage its not cheap, maybee i can 3dprint one i also have lathe
-
@kered said in EleksMaker Brand New Draw Module:
i'll wait a bit as comined with postage its not cheap, maybee i can 3dprint one i also have lathe
yes...because we only mail by air..... maybe you can made your own and share to everyone , looking forward
-
There is no shipping method and contact page on your website does not work
-
@dany4j said in EleksMaker Brand New Draw Module:
There is no shipping method and contact page on your website does not work
maybe your zone is not in our setting mailing area .... sorry , could you please tell me your country?
-
Is it possible to order it to Germany? Or will you put it in the banggood store soon?
-
@faster-master said in EleksMaker Brand New Draw Module:
will you put it in the banggood store soon?
we will put it in the banggood store soon , thanks for support
-
do we have to change the control board?
-
@Thomas-George said in EleksMaker Brand New Draw Module:
do we have to change the control board?
nop3 , you dont need change the control board , but you need use our firmware and use EleksCam or T2 to switch laser/draw mode
-
@EleksMaker-Z sorry, my question was incomplete.
I had recently bought a A3pro and completely new to this..so if I want my A3 to be a pen plotter , do I have to buy the zaxis, control board and draw module?
Thanks
-
no you need the draw module.
You could use a z axis and a 3 axis control board but that would be way overkill. You could then push down really hard with your pen.... would probably just break it.
But all you need is the draw module. $9 plus shipping.
-
@Thomas-George
just buy the draw module , you dont need new controler and Z Axis
-
Very awesome.
Where are instruction on how to use draw module? Very awesome Eleksmaker provide such a thing. Where is instruction on what port to plug into? If servo plugged into laser servo is destroyed. If servo plugged into servo how are software settings changed to make eleksboard send servo up/down signal?
Without VERY VERY IMPORTANT instruction, many people will destroy the servo.
-
@Anatoly
http://wiki.eleksmaker.com/doku.php?id=draw_module here is how to Assembly thatand for software user instructions you can see http://wiki.eleksmaker.com/doku.php?id=eleksdraw (EleksDraw)
and we have a free chance to get draw module now :http://forum.eleksmaker.com/topic/992/christmas-theme-laser-engraving-works-awards-collect