No, there is nothing mechanical stopping the movement of the machine

Hello,

I am currently new to this and am running an Eleksmaker that I recently acquired from someone who passed away. I believe it is a 2.5 W laser and it has three axis setup on it.
I have been able to successfully use the laser using LaserGRBL V3.1.2 software. I initially tried EleksCAM but without any success (the port will say it is connected but the software does not seem to be able to control the laser at all). When about a quarter of the way through a job using LaserGRBL the system suddenly stops and just goes back and forth making lines instead of continuing the job.

Do you have any advice on how to make this stop? Is there a simple fix to why ElekCAM won't work and if it did, would it stop my problem with the lines?

Thanks in advance.