Thanks for all the answers.
can you please attach a link (url) where i can order a new part?
Re: Eleksmaker A3 Pro X-axis dont work.
I have now measured how much volts (DC)the stepper driver gives.
The X-axis is dead, it does not produce any output (DC). I turned gently on the screw both ways, but still no output/DC on the stepper driver for the x-axis.
I also measured the y-axis. It provided output / DC as it should.
It looks like the stepper driver "card" is broken.
What do you think?
With best regards
Hi and thanks for the quick reply.
I have tested putting x-axis motor cable on the y-axis. Same problem. it will not move.
Do you have any instructions on how to check / measured: "the stepper driver current limit"?
(Do I need to measure the output with a multimeter on the red "chip" on the right side of the image?
To find out if enough volt / power is given to the stepper motor?
If not, turn the screw (see picture) until it gets the correct volt / power?)
As you see, I'm not an electrician
Thanks for all possible answers!
I have a problem that I can't figure out.
The X-axis does not work, but the y-axis works as it should.
When I use the arrows keys (in EleksMaker software) only the y-axis moves, when i try the x-axis, the motor only makes a small "sound", but does not move.
I thought it was the x-aksis motor problem. So I ordered a new one from you, but unfortunately it didn't get any better after i changed it with the new one i got.
Do I need a new motherboard (Mana)?
I've only had this EleksMaker for approx. one month. It has worked perfectly with
what I have engraved. (Not mutch tho) But now the x-axis does not work.
The laser works.
Any idea of what's wrong?
EleksMaker A3 Pro
Mana SE v3.2
Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.