@Zax i dont now how but i have 1
and i will contact the seller i will cancel the a5 destop
done that also now
@pledgy and what i see on the below side off the dir pin from arduino i not even soldered to the board there is a gap between the pin and the board around the pin from arduino to the board so i bend the pin littel bit and there is contact piiiiieeeepppp on mij multimeter shell i give it a tiny drop of tin and it suld the solution mybe i will made foto before the iron gets hot thank you very much that you have take the time to tell me this i will be back
@Zax i have build a own laser cutter frame whit 3d printed parts it has play ground 360mmx560mm build on playwood plate off 25mm
and in few hours i will order the eleksmaker a5 desktop the new board mana controller is already on his way to the nederlands
@nottingham82 i have done that yet it works fine accept the x carrier i belive the board is on x terminal dead but is it my be possible to change z terminal to x terminal end z terminal to the dead end i dont need z mybe some body can help me whit this if i set the x stepper on y terminal it works fine bold sides the Original x terminal cant take it any from me
Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.