Posts made by davester13
RE: Draw module: Servo trembles
Thank you very much for your answer!
In fact, I did first connect the servo and then I changed the settings...
I will get a new servo and hope that it will work then.
Is there anything I need to take care of when I switch back to the laser module?
Draw module: Servo trembles
I am using T2 since quite a while for lasering and it works great!
Now I bought the draw-module for my Elekslaser and it just does not work.
While the homing position is about 45°, it goes down pretty slow and does not go up again. It does however trembles the whole time and goes up to 45° veryyyy slowly (takes about 30 seconds).
I switched the firmware to 0.9i, activated servo mode, put max. laser power to 35 and tried many other options. Any ideas?