I am using Lightburn.
Arduino comes with something called avrdude that lets me
upload a compiled binary to the arduino.
If there is a pre-configured source code that has the eleksmaker
A3/A5 changes built in I would gladly build and upload
:DES.
I am using Lightburn.
Arduino comes with something called avrdude that lets me
upload a compiled binary to the arduino.
If there is a pre-configured source code that has the eleksmaker
A3/A5 changes built in I would gladly build and upload
:DES.
Re: Obtaining and using GRBL 1.1e for EleksMaker
Is there a binary file I can upload using the Arduino IDE firmware uploader?
I am working exclusively in Linux and don't want to install windows for one job.
Thanks.
I looked at the gcode tool but all of the inkscape versions are different.
Has anyone gone through this in Linux and have some hints?
Thanks.
@Zax Thanks for the answer. I must have been unclear.
I do not have windows. That means I can't run EleksCAM
without inconveniencing my friends.
I am looking for the 1.1e firmware for the A3 Pro as a standalone.
The version shipped is detected as pre-1.1.
I just assembled my new A3 Pro with the 5.5W laser.
I use Linux, so the default software is not an easy option.
LightScribe suggests using the $$ command to get
the current settings, and they are expecting there to be
a $30 setting, which my firmware does not have.
Thank you.