Thankyou for getting back to me ive flashed the board using the eleksmaker reset rom button, then uploaded the GRBL 1.1F i cannot find the 1.1e version hen downloaded T2 laser it connects and reads the firmware successfully but again when i click the up, down, left, right button the motor still goes in 1 direction.
Posts made by elliscrane
RE: LASERAXE SWITCH TO ELEKSMAKER
LASERAXE SWITCH TO ELEKSMAKER
Good Afternoon, I hope your all well.
The problem i am facing it, I have bought a Chinese Laser engraver from Laseraxe that apparently only supports the software CCNC.
That software is not my favourite to i downloaded my favourite software by Eleksmaker which required me to flash the board, in the software it connect fine but if i click up, down, left, right the motor will only go one way until it has reached it limit the laser come on/off fine but the preview/movement of the motors dont work at all.
i was enquiring if i purchased an official board by eleksmaker and switched them would this increase the chance of my engraver working again.
kind regards - ellis