Had a play with making some decorative pieces for the house. Used Squiggledraw to make these.
giek2000
@giek2000
Posts made by giek2000
-
Single line drawings.
-
RE: Christmas Cards for EleskDraw
@marco-rizzi said in Christmas Cards for EleskDraw:
Ciao ti faccio una domanda ,ma dove si può scaricare il software EleskDraw,
I use T2 laser with my Elekslaser with Draw module.
-
Christmas Cards for EleskDraw
I've made a few single line christmas cards i've drawn on black card stock with glitter / metallic pens. Pretty happy with them
-
Elekslaser A3 CNC / Z Axis Mount
Not wanting to permanently attach the Z axis as i use the drawing attachment frequently, i made this mounting 'block' for the Z axis. It's 90% there. Still need to fix some of the alignment but all holds in place securely.
Download here.
-
RE: Engraving Carbon Fiber
@maikel85t Yep worked pretty easily with the 2.5 laser. No other tips really!
-
RE: problem with servo
Install 0.9i EleksMana firmware with T2, then enable Servo Mode in Settings > Configure EleksMana.
-
Mana 3 Axis Controller Mount STL
Not so much something made with the EleksLaser as it's something for the EleksLaser. Recently got the 3 axis Mana Board but needed a way to mount it. Read i'm not the only one and this might be of use for some people.
Download here on Thingiverse!
-
RE: A3 Z-AXIS 555 Motor Help
Thanks Zax. Will give it a try.
On another note, is the 5A power brick sufficient for A3 + 555 motor?
My gut tells me no but happy for someone to prove me wrong. -
A3 Z-AXIS 555 Motor Help
Hi all,
I was wondering how everyone are powering their 555 motor? Via the 2 pin plug to the mana or powered separately via the circular plug? Or do we need both? Also is it possible to set motor speed much as we would laser power?
Many thanks all
-
RE: Few bits i've made.
@aph1878 Thanks
I used 250 or 320gsm paper and the map is engraved on it.