I purchased the EleksEgg a couple of years ago and it never worked. I thought maybe the software/firmware was finally fixed (very irritated that they were selling something that didn't work). I tried downloading the software and it won't install with Windows 10 - just says can't intall. Did EleksMaker finally give up on this product? Any suggestions.
heedaf
@heedaf
Posts made by heedaf
-
EleksEgg Status
-
RE: Servo makes ratcheting sound but does not move
@EleksMaker-Z - Tried a 2nd servo and has the same problem. I'm guessing there is something wrong with the software/firmware.
-
RE: Servo makes ratcheting sound but does not move
@nottingham82 Nope! Tried that and it didn't help.
-
RE: Servo makes ratcheting sound but does not move
@sstouk Thanks! Tried 10% and every other % without any luck.
-
RE: EleksROM V3.6 丨 Full AutoMactic Upgrade And Set Param SoftWare - Download && Instruction
I got a new servo and it is doing the same thing. Any other ideas?
-
RE: Problem with servo
Yep! Tried everything. Looks like they have some serious issues going on.
-
RE: EleksROM V3.6 丨 Full AutoMactic Upgrade And Set Param SoftWare - Download && Instruction
@Zax I type E3 and hit send but the servo just keeps rotating clockwise no matter what the laser power is set to. Any other ideas?
-
RE: Problem with servo
@MuuSer Thanks for the reply. Any power setting will just rotate the servo all the way clockwise. Very strange.
-
RE: EleksROM V3.6 丨 Full AutoMactic Upgrade And Set Param SoftWare - Download && Instruction
E3? I did try A0 and it didn't help.
-
RE: Servo makes ratcheting sound but does not move
I've tried everything in every combination. Reading the post I'm a little confused on the commands. One post said that if you update the firmware and select the egg option commands are not needed. Maybe I'm sending the commands wrong, is there a specific way of doing that? When I'm running the program I can see 31 and 0 being sent but the servo just keeps rotating clockwise until it hits the threshold.