I am laughing all the way to the fire extinguisher, too.
I am lasering leather and even with fans on my shop smells like a burnt cow at start up. +
I have ordered the resistors today.
hw in bda
@hw in bda
Posts made by hw in bda
GCode will not generate from T2Laser
When I send to device, the GCode generation pauses at 24% to 29% and then asks if I want to save the code.
I get this in the T2Controller top panel:
( Generated by T2Laser )
( Image2Gcode for Grbl )
( Start Point: LL )
( Frame Mode : Abs. )
( X Maximum : 198.2 )
( Y Maximum : 280.4 )
( Laser Max : 5 )
( Feed Rate : 3000 )
( Resolution : 0.2 )
( Image Name : Hairline Diamonds to laser.jpg )
G00 X0 Y0
And this in the bottom panel:
Total Lines: 18
GCode Lines: 8
Estimated Time: 0 second
Total Distance: 0mm (c0/r0)
And obviously there is nothing there to etch.
I have had this issue today, whereas yesterday I was etching normally, well burning leather, but its a learning curve.
I have just noted that when it stops generating the gcode it says 18lines and done.
Can anyone offer help, thanks