you need to elevate the piece and then run multiple passes
Posts made by mrmister
-
RE: Cutting Mat Board
-
RE: New start up
You need to provide WHEN you get the error. That describe the steps you are taking, and when the error occurs.
-
RE: Elekscam screen resolution
This problem was brought up many months ago. It is a known problem.
-
RE: EleksLaser A3X IMPOSSIBLE TO COLLECT!
and search for wheels too tight
-
RE: A3 Pro Laser Always On
@Roy-Killington
@Roy-KillingtonAs stated, stepper generate electricity, so rapidly moving the stepper back and forth generates what is needed to activate the laser.
The CABLE from the mana board to the laser - ensure that wire color match the pins from the board to the laser. If you have a volt meter check that the wires are not broken.
-
RE: A3 Pro Laser Always On
Post a video.
The laser "might" fire, I doubt it though, when unplugged and when you are moving the gantry because stepper motors generate electricity.
-
RE: 2 axis board not working with stepper motors
Did you splice the Y axis cables?
Look at the color pattern on one Y port you have from left to right: Blue, Red, Green, Black.
On the other Y port you have from left to right: Red, Blue, Black, Green
-
RE: Laser started making a beeping sound when on
It is hard to tell. The fans blades as mentioned OR the noise of the steppers.
I have to thump my fan at start up to get it to stop making a horrendous sound.