My version of an Eleksdraw inspired by the Elekslaser frame.
Still got to make the pen lift and a proper belt clamp but its moving nicely.
Best posts made by pledgy
For anyone that does not like to wait for the screen to fade when you close the program just press the X twice. I did it by accident and found out.
RE: Windows10, GRBL and LaserWeb 3 support
I am still on Windows 7 so cant help with that.
Elekscam will not currently work with 1.1 but will work with 0.9.
The setup values I am using are
$0=10 (step pulse, usec)
$1=25 (step idle delay, msec)
$2=0 (step port invert mask:00000000)
$3=0 (dir port invert mask:00000000)
$4=0 (step enable invert, bool)
$5=0 (limit pins invert, bool)
$6=0 (probe pin invert, bool)
$10=3 (status report mask:00000011)
$11=0.010 (junction deviation, mm)
$12=0.002 (arc tolerance, mm)
$13=0 (report inches, bool)
$20=0 (soft limits, bool)
$21=0 (hard limits, bool)
$22=0 (homing cycle, bool)
$23=0 (homing dir invert mask:00000000)
$24=25.000 (homing feed, mm/min)
$25=500.000 (homing seek, mm/min)
$26=250 (homing debounce, msec)
$27=1.000 (homing pull-off, mm)
$100=80.000 (x, step/mm)
$101=80.000 (y, step/mm)
$102=80.000 (z, step/mm)
$110=5000.000 (x max rate, mm/min)
$111=5000.000 (y max rate, mm/min)
$112=5000.000 (z max rate, mm/min)
$120=500.000 (x accel, mm/sec^2)
$121=500.000 (y accel, mm/sec^2)
$122=500.000 (z accel, mm/sec^2)
$130=500.000 (x max travel, mm)
$131=500.000 (y max travel, mm)
$132=500.000 (z max travel, mm)
RE: Using A3 Laser frame to test Tangential Knife software.
That was inkscribe and Gcode tools extension. I used the Z axis on a 3 axis board and changed the A or C axis (can't reme which) that gcode tools outputs to Z to work with grbl. I will dig out some more info when I get to my PC.
RE: OUTLINE Function doesn't work
Try running Elekscam as administrator
RE: Not move
@Dániel-Váradi Change your Windows regional settings to use . instead of , for decimal separator.