Hope it displays it now
Posts made by sharkovios
RE: EleksMaker Z axis Spindle Always ON
doesnt the picture in the post help?
EleksMaker Z axis Spindle Always ON
I have an A3 pro and recently bought a EleksMaker Z axis with spindle and a mana board.
I have connected the barel type connector cable at the motor and the other side (jst) to the port motor or GND/M3.
When i power on the board, the spindle is turning on and not responding to M3/M5 gcode commands.
I have reuploaded the firmware from EleksROM but still...
Has anyone any idea?