I have started to enagrave my first pictures using EleksDraw and Laser 2.5 W. I'm using Eleks CAM V3.1
The picture that used Outline mode has been engraved successfully but the machine has two problems:
- In preview mode, the laser generates thin lines (yet visible) that connect the four corners;
- When engraving in Scan mode, the laser continues to engrave a litte bit nearly the engraved zone.
The attached picture has been generated using Outline mode except for the two dot points on the left side (upper and lower corners): the cross lines, generated during the preview, are still visible and also near the dot there are phantom lines or better bands. [Don't consider color that has been added manually, but the letter edge has been engraved successfully).
I have used the following parameters in the Settings tab
In the Control tab:
Speed: 1000 mm/min
Sport-T: 20 ms
Repeat: 1 times.
On the main toolbar: Laser ON, Weak ON (?)
I do not know if the parameters are correct or if there is a software/hardaware issue, even if Outline mode runs as explected. May be I have used the application badly.
Finally, does it exist a sort of table to configure parameters properly?
Thank in advance.